Master Network Series: Wired network installation and maintenance must also evolve as networks evolve. The MTA1000A is customized easily for every measurement by changing modules.
MU100090B High Performance GNSS Disciplined Oscillator - Sync Module
Commissioning and Verifying Mobile Backhaul
The MU100090B is an atomic-clock oscillator module providing reference timing to test network synchronization. It supports GPS, GLONASS, Galileo, Beidou, and QZSS as a reference timing source.
Features:
- Time Error Measurement: Measures phase difference from 1 PPS/PTP Packet nming based on GNSS signal
- Evaluation of PTP/SyncE synchronized network
- At the network edge, the MU100090B emulates a slave clock to monitor timing distributed to the network.- max|TE| (absolute Time Error), cTE (Constant Time Error), dTE (Dynamic Time Error), wander (MTIE, TDEV) and pktSelectedTE as metrics of phase/time synchronization.
- One-way delay (OWD) is measured to evaluate PDV and FPP.
- SyncE Wander by TIE, MTIE, TDEV metrics
- SyncE Wander Measurement
- Protocol Functional Test
- After a PTP session is established, the tester displays various status conditions announced from the network and measures message rates.
- Supported Profiles: G.8265.1, G.8275.1, G.8275.2, SMPTE2059-2 and customized parameters.
- Ethernet One-Way Latency Measurement: Synchronizes two MT1000A units for one-way high-accuracy latency measurements between separate localities
Specs:
- Internal Oscillator: Rubidium atomic clock
- External Clock Output 10 MHz: Connector: BNC Jack/50 Ohms (nom.); Level: TTL
- 1PPS Sync Input:
- Usage: Synchronize the internal oscillator with this 1PPS, ITU-T G.703
- Connector: BNC Jack/50 Ohms (nom.)
- Level: TTL
- Input Frequency Range: ±10 ppb
- 1PPS Reference Output:
- Connector: BNC Jack/50 Ohms (nom.)
- Level: TTL
- Polarity: Positive/Negative
- Antenna Input:
- Connector: SMA Jack/50 Ohms (nom.)
- Feeding Antenna: Off/+3.5 V/5 V Slectable, 50 mA max.
- AUX Output:
- Usage: Provide MT1000A with ToD (NMEA0183) with J1705 (AUX interface adaptor)
- Connector: D-SUB 9 pin
- Supported Signal:
- GPS L1C/A, L2C
- QZSS L1C/A, L2C
- Beidou B1I, B2I
- GLONASS L1OF, L2OF
- Galileo E1B/C, E5B
- GPS L2C, QZSS L2C, GLONASS L2OF, Galileo E5B, Beidou B2I are available after MU100090B-001 is installed.
- QZSS, GLONASS, Galileo, Beidou are available after MU100090B-002 is installed.
- Number of Receivable Channel: 50 channel
- Time Accuracy to GNSS Time:
- Without MU100090B-001: ±45 ns rms*
- With MU100090B-001: ±10 ns rms*
Standard Accessories: AUX Conversion Adaptor, GNSS Antenna, BNC Cable (20 cm) × 2, Tripod for GNSS Antenna
