Aim-TTi I-prober 520 Positional Current Probe, DC to 5MHz, PCB Track Touch/Measure

I-probe 520 PCB track Touch and Measure

Features:

• Current measurement from isolated probing of conductor
• Dynamic range of 10mA to 20A peak to peak
• Wide bandwidth of DC to 5MHz
• Low noise equivalent to <6mA rms
• Safety rated to 300V Cat II
• Suitable for connection to any oscilloscope
• High accuracy general purpose H-field probe
• Convertible into 'closed magnetic circuit' current probe
• No requirement to break or surround the conductor
• Observe and measure currents in PCB tracks directly
• Minimal disturbance to circuit conditions through very low insertion impedance and stray capacitance
• Useable in confined and difficult to access spaces
• Measures current into surface mount components, IC legs and short component leads
• Can observe currents flowing within ground planes
• Useable on high-voltage conductors and in high temperature areas

Includes: A fitted carrying case which accommodates all of the items including the power supply, instruction manual and calibration graph.

The Aim-TTi I-prober 520 is a unique current measurement device. Measurement of current normally requires it to be passed through a closed magnetic loop, typically using a split clamp device. Whereas this is suitable for individual wires, it is of no use for measuring current in PCB tracks. The I-prober 520 uses positional H-field measurement. By placing the insulated tip of the probe onto a PCB track, the current flowing in the track can be observed and measured. The I-prober 520 is supplied with a clip-on toroid assembly which converts it into a closed magnetic circuit probe for measuring current within a wire.