Tripp Lite B160-201-HSI HDMI over IP Extender Kit with Built-in 2-Port Splitter, RS-232 Serial and IR Control, 1080p 60 Hz, 328 ft. (100 m), TAA

• Units connect point-to-point without a switch up to 328.08-ft. (100 m)
• Supports video resolutions up to 1920 x 1080 (1080p) @ 60 Hz
• Dual HDMI outputs on receiver for connecting 2 displays
• Plug and play—no software or drivers required

Converts HDMI audio/video to an IP-based signal that is transmitted point-to-point to a display 328 ft. away via Cat5e/6 cable or through a dedicated Ethernet network switch.
Extends and Distributes HDMI A/V, Serial and IR Control Signals over Cat5/6 Cabling
•Converts audio/video to an IP-based signal that is transmitted point-to-point to a display 328.08-ft. (100 m) away
•Add low-cost network switches between transmitter and receiver to continue extending distance up to 328.08-ft. (100 m) per switch
•Dual HDMI outputs on receiver for connecting 2 displays
•HDMI output on transmitter for connecting a local display Create a Multi-In, Multi-Out Installation Using B160-Series Transmitters and Receivers
•Connect up to 64 transmitters and 255 receivers through multiple dedicated managed network switches
•IGMP-enabled switches allow centralized control over which sources show on which displays
•Video source can be sent to any analog or digital display, so you can mix and match technologies and use existing monitors Enhanced Technical Features
•Supports video resolutions up to 1920 x 1080 (1080p) @ 60 Hz
•Uses H.264 video compression standard
•Transmits on 20-60 kHz IR frequency
•Extends IR control signals that control a source from a remote display
•Supports RS-232 serial baud rates up to 57600 Bps
•HDCP and 3D compatible Plug-and-Play Functionality
•No software or drivers required
•Hardware included for mounting on wall, rack or pole TAA-Compliant
•Compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases