Pico Technology PQ215 Holder Kit, Fits 4 Probes And 4 PCBs, PicoScope 6000 Series

PQ215 Holder Kit For Probes and PCBs

The kit is ideal for making hands-free measurements, for PCB inspection, and even as a soldering station.

Kit Includes:

• A4-sized (about 11" x 9") steel base plate
• 4 PCB holders
• 4 probe holders (probes not included)
• 8 colored elastic cable ties:
  (blue, red, green, yellow, purple, gray, light blue and magenta)

The PQ215 probe holder and PCB holder kit is a valuable accessory to your PicoScope 6000 Series oscilloscope. It has been designed exclusively for use with the 2.5 mm probes included with every PicoScope 6000 Series oscilloscope past and present (TA061, TA062, TA101, TA151, TA133, P2036 and P2056).

The base plate provides the secure footing for your probe positioning system. It's mirror finished, allowing you to see the underside of the PCB to view any status LEDs during test.

Your PCB is fixed into place with four powerful magnetic posts employing spring-loaded clamps to grip the PCB under test. The clamps use a pair of replaceable insulating washers to avoid shorting tracks on the PCB.

With strong magnets at their base, the four gooseneck probe holders offer a flexible way to position the probe tip while holding it firmly poised in place. Their unique design employs a precisely weighted probe holder that pushes the sprung probe tip just enough to make a good contact on your PCB or unit under test. The probe holders include eight pairs of silicone cable ties. These stretchy rubber ties secure the probe cable to the probe holder gooseneck, adding stability and also a neat way of identifying which probes are connected to which channels, which is handy with a four channel oscilloscope and especially useful with an eight-channel oscilloscope.