34951A 4-Channel D/A Converter with Waveform Memory for 34980A
- Four isolated analog outputs
- Output up to +/-16V DC or +/-20mA DC
- 16-bits of resolution
- 200 kHz update rate
- Default standard waveforms
- Onboard memory to create your own waveforms
Keysight 34951A module for the 34980A Multifunction Switch/Measure Unit has four electronically calibrated analog channels that can output up to +/-16V DC or +/-20mA DC with 16 bits of resolution. Each channel can be updated individually with a 200 kHz update rate. You can use the standard waveforms provided or create your own with over 500,000 points. These points can be dynamically allocated among one or more channels and output as a point-to-point arb.
These D/As are useful to source bias voltages to your device under test, to control your analog programmable power supplies, or use the outputs as setpoints for your control systems. Standard 50-pin Dsub connectors allow for use with standard cables, terminal blocks, or mass interconnect solutions.
- N9915B – 9 GHz FieldFox Microwave Analyzer
- Base model includes cable and antenna analyzer
- Expand capabilities with optional vector network analyzer, spectrum analyzer, real-time spectrum analyzer, and more
- Capture intermittent signals with 100 MHz gap-free real-time bandwidth
- Simultaneously measure all four S-parameters with 115 dB system dynamic range
- Make accurate spectrum analyzer measurements (±0.3 dB) without warm-up
- Validate network performance with over-the-air measurements for 5GTF and LTE
- GPS/GNSS receiver for geolocation and time stamp precision
- Lightest all-in-one analyzer at only 7.35 lb. (3.34 kg)
- New high capacity battery providing over 5 hours of battery life
FieldFox, the industry’s most versatile portable analyzer, has launched this new line of future-ready analyzers to address the ever-increasing demands of 5G, satellite communications, signal monitoring and electronic warfare applications. All existing FieldFox A Series measurement capabilities (except QuickCal) are supported on the new FieldFox B Series. 100 MHz (Option B10) and 40 MHz (Option B04) analysis bandwidth options will be available on the B models, with 10 MHz as the standard option.
- Up to 100 MHz of analysis bandwidth, I/Q capture and real-time bandwidth, wideband IF output
- 10 dB improved DANL over previous generation FieldFox, up to 15 dB better in some bands
- Greater than 115 dB VNA system dynamic range
- New high output power source >8 dBm in some bands
- 10 dB improved phase noise over previous generation FieldFox
- 5G NR and LTE-A demodulation with 89600 VSA software (Optional)
- Over-the-Air (OTA) measurements for 5G TF and LTE FDD (Optional)
- Supports record and playback of I/Q capture that can be analyzed with custom I/Q open architecture solutions (Optional)
- Multi-GNSS (Global Navigation Satellite System) support for geolocation and time stamping: GPS+SBAS, GLONASS, BDS, Galileo (Optional)
