Pace 1121-0942-P5 .030" Precision Tip for Desoldering Iron

• Tip for desoldering iron
• The Inside Diameter (I.D.) of the tip must be large enough to fit over the lead, while providing sufficient room so that air and solder can be drawn through the tip
• The Outside Diameter (O.D.) of the tip must be slightly smaller than the diameter of the pad to prevent tip contact to the board laminate and minimize the possibility of damage

Precision tips are designed to remove solder from through hole joints where access is an issue and ThermoDrive tips wont fit between the pins. The ID of the tip should be slightly larger than the OD of the pin being desoldered.