D9010USBP/R-B5P-001-A/R-B6P-001-L Protocol Decode/Trigger Software
Configurations:
- (R-B5P-001-A) Node-locked perpetual license
- (R-B6P-001-L) KeysightCare software support subscription, node-locked – 12 months
This application includes a suite of configurable protocol-level searches and software-based triggering specific to all USB standards. It is compatible with EXR-Series, MXR-Series, UXR-Series, S-Series, V-Series, and Z-Series Infiniium oscilloscopes. USB4 and USB 3.2 trigger and decode are not available for the EXR-Series, MXR-Series or S-Series oscilloscopes.USB4 and USB 3.2 trigger and decode are not available for the S-Series oscilloscopes. For detailed information on the decode and trigger settings, please refer to the datasheet. For assistance with using the applications, refer to the Infiniium help guide.
Features:
- Get your USB testing of any speed done faster with this all-in-one USB trigger and decode package
- Set up your scope to show USB4, USB 3.x, USB 2.0 and eUSB2 in less than 30 seconds with an auto setup feature
- USB4 will be added to this package moving forward (with an active support subscription)
- Get access to a rich set of integrated protocol-level triggers and searches – see datasheet for a complete list
- Save time and eliminate errors by viewing packets at the protocol level
- Use time-correlated views to quickly troubleshoot serial protocol problems back to their timing or signal integrity root cause
D9010SCNA/R-B5P-001-A/R-B6P-001-L
Configurations:
- (R-B5P-001-A) Node-locked perpetual license
- (R-B6P-001-L) KeysightCare software support subscription, node-locked – 12 months
A 100-ps glitch, a non-monotonic edge and 80-bit serial patterns. No hardware solutions were capable of capturing any of these signals, but with InfiniiScan you can. Keysight Technologies’ InfiniiScan event identification software allows you to quickly and easily identify signal integrity issues in your electronic designs. This innovative software scans through thousands of acquired waveforms per second to help you isolate anomalous signal behaviors.
Features:
- Zone Quality Finder draws up to 8 “must pass” or “must not pass” zones on scope screen
- Measurement Finder sets boundary conditions to specified measurement and finds them
- Generic Serial Finder sets up an 80-bit serial pattern for trigger
- Non-monotonic Edge Finder easily identifies edges caused by reflections
- Runt Finder identifies under-sized signal pulses
- Measurement Limit Test counts violations against user-specified measurement values
- Set up to five different triggering conditions over all 4 analog channels
Hightlights:
- Application scans through over one thousand waveforms per second
- Isolate anomalous signal behavior
- Trigger on up to 8 zones across multiple channels
Compatibility
- Infiniium 9000, S-Series, EXR-Series, and MXR-Series oscilloscopes running firmware 6.30 or later
